We offer CAE services including Moldflow, structural/stress analysis, die-casting, CFD, thermal, durability and metal stamping simulation. We use software like Hypermesh, Hyperview, Hyperform, Optistruct, Abaqus, ls-Dyna, Ansys Fluent, Autodesk Moldflow Plastic Insight, PAM-STAMP and ProCAST. […]
Consulting
If you need any technical help for part design, Moldflow, hot runners, mold design review and processing help, please reach out at krish@polymerschool.org
Hotrunner Tech on-demand
Are you looking for hotrunner service tech help? You are in the right place. We can send a hotrunner tech to you facility to fix any hot runner; single cavity to 256 cavities. We can […]
Moldmaker on-demand
If you are looking for moldmaker to assemble, fix and refurbish a mold or extra hand to finish a mold, we have resources in USA. We will travel to your facility and fix the mold. […]
IV Explained – Part 2
This blog is a continuation of the IV Explained – Part 1 blog which I recently did. This blog explains the properties and practical use of IV and measurements during processing.
IV Explained – Part 1
In this video blog, you will learn the theory of IV (Intrinsic Viscosity). We take you through why IV is used, and how it is calculated and basics of measurements.
Concepting a milling fixture
This blog is a continuation of the drill jig video blog I recently did. Here we take you through concepting a milling slot on the same workpiece/part and explaining step by step.
Concepting a Drill Jig
We take you through an example of concepting a drill jig. How to locate, orient and clamp the workpiece, and finer details of design. This blog is useful for any designer who wants to design […]
Electrification of Mold Actions-Part 1
This blog introduces you to servo control for the mold actions. We cover why servo control is better than Pneumatic or Hydraulic systems, and advantages. Second part of this blog will cover the selection and […]
Exaflow- Gate Inserts
Manufacturing a sub gate or a tunnel gate or a cashew gate inserts are very complicated and it takes lot of time and effort in manufacturing. Exaflow gate inserts are a simple solution to this […]
Core & Cavity
Core and cavity are the important elements of a mold. In this blog, we take you over the basics of core and cavity design and factors to consider during design.
RJG’s Decoupled Molding – Explained
In this blog, we explain RJG’s Decoupled molding principles, and advantages on the process consistency. We take you from basics of decoupled molding for new process engineers.
CrystAllinity in Polymers
Crystallinity in a semi-crystalline polymers is important for achieving material properties. This blog takes you through the basics and factors affecting the crystallinity in polymers.
Viscosity Models
Viscosity models are used in day to day calculation in polymer industry. This blog explains viscosity basics, different models and models used in Moldflow and Moldex3D simulation software.
Hotrunner Balance Study – Factors
This blog is continuation of the earlier blog on “Hotrunner Balance Study – Test Methods”. Here we explain all the factors that affect the balance with some examples which will helpful for troubleshooting the issues […]